Help....Clutch install
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: May 2005
Location: Katy, TX
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Help....Clutch install
OK, I am installing a clutch in an 02 z28. I got it out fine came apart rather easy. Now that I have started to put things back together the transmission will not seat all the bolts are lined up and have been started. Can I just tighten them from side to side. Just checking cause I dont want to strip out one of the bolts.
#2
TECH Veteran
iTrader: (10)
make sure the tranny imput shaft it level so it goes into the pilot bearing and then it will go all but like a half inch which is just the spring pushing against you, if you really push it will go and then slide back out if that is what it is, normally i will just start all the bolts and let them pull the tranny in