MCleod Adj. Master Cylinder
Thread Starter
Launching!
Joined: Jan 2002
Posts: 254
Likes: 0
From: Plymouth,MA
MCleod Adj. Master Cylinder My clutch pedal is releasing right at the top of pedal travel with my Street Twin clutch in my LT1.Will this fix it and let me adjust pedal height?
How hard is it to install?
Any help is appreciated <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Thanks
John
How hard is it to install?
Any help is appreciated <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Thanks
John
TECH Apprentice
Joined: Nov 2001
Posts: 363
Likes: 0
From: Bolingbrook, IL
Re: MCleod Adj. Master Cylinder I wount be the best help, but I will tell you the install is not hard at all, pretty easy. Bleeding the unit is a big PITA (in my case at least) I am going to attempt to reverse bleed the system @Power House Performace on Friday, so in my case the bleeding is the worst part. Its probably not that bad, but I think that little air bubbles got into the lines durring shipping so its a PITA to get them out. Good luck with yours and I hope yours goes more smoothly. I recomend checking out www.installuniversity.com for more information, they have a good write up on it..Michael
Thread Starter
Launching!
Joined: Jan 2002
Posts: 254
Likes: 0
From: Plymouth,MA
Re: MCleod Adj. Master Cylinder Micheal,
Thank's for the help.That install page was helpful also.
Does anybody know if you need to do the drill out mod on a 96 or if the restriction is only on the 98-02's?
thanks again
John
Thank's for the help.That install page was helpful also.
Does anybody know if you need to do the drill out mod on a 96 or if the restriction is only on the 98-02's?
thanks again
John
Thread Starter
Launching!
Joined: Jan 2002
Posts: 254
Likes: 0
From: Plymouth,MA
Re: MCleod Adj. Master Cylinder anyone?
How hard is the install?Do I have to bleed the
system afterwards?
thanks
John
<small>[ March 27, 2002, 12:26 PM: Message edited by: Vortech396 ]</small>
How hard is the install?Do I have to bleed the
system afterwards?
thanks
John
<small>[ March 27, 2002, 12:26 PM: Message edited by: Vortech396 ]</small>
