How to adjust the Mcleod Master?
04-15-2002, 02:03 AM
#1
On The Tree
Thread Starter
Join Date: Nov 2001
Location: Boston , MA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
How to adjust the Mcleod Master? I just got a Ram clutch and a Mcloud adjustable master....it catches at the floor, it's so bad that I can't speed shift or anything, how do I move the engagement point up?
Lawrence
Lawrence
04-15-2002, 08:03 AM
#2
Coal Mining Director
iTrader: (17)
Join Date: Nov 2001
Location: Virginia
Posts: 4,442
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to adjust the Mcleod Master? Pull the plastic panel above the clutch pedal off. Look at the clutch linkage and you'll see a metal clip on the end of the master. Pull the clip off with needle nose pliars. Loosen the retaining nut on the master shaft.Slip the shaft off the linkage and turn the head one full turn clockwise...slip it back onto the linkage and see if it helps the engagement...if not keep adjusting one turn at a time to get it right....you may have to play with clockwise vs counterclockwise as my memory is fuzzy.
04-17-2002, 12:14 AM
#3
Staging Lane
Join Date: Nov 2001
Location: Connecticut
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to adjust the Mcleod Master? Laurie, how do you like the Ram.? Is it the sintered iron disk with HD pressure plate.?
<small>[ April 17, 2002, 01:18 AM: Message edited by: ATIrich ]</small>
<small>[ April 17, 2002, 01:18 AM: Message edited by: ATIrich ]</small>
