Clutch Scared!
Thread Starter
Banned
Joined: Jan 2006
Posts: 200
Likes: 0
Clutch Scared! I purchased a Spec 3 from Tybrne with the Hybriad option and light weight pressure plate option. My engine builder was to assemble and balance it with my engine work.
Anyways, the alignment pins one th stock Zo6 are .236 dia. and the holes one the Spec pressure plate are .265 dia. Spec and Tybrne said it was fine. My engine builder and Andy From A&A said it wasn't. My guy modified my pins to match and I'm left praying that this thing is going to function O.K.!
Anyways, the alignment pins one th stock Zo6 are .236 dia. and the holes one the Spec pressure plate are .265 dia. Spec and Tybrne said it was fine. My engine builder and Andy From A&A said it wasn't. My guy modified my pins to match and I'm left praying that this thing is going to function O.K.!
