Slave shim pattern
Slave shim pattern Does anyone have a drawing showing the proper dimensioning for a shim between the slave and transmission? I would like to fabricate a few in different thicknesses before I pull the trans this weekend.
I intalled a SPEC 2 (bought it barely used from a forum member last year) that did not have the shim from SPEC included. The pedal engages a bit too close to the floor for my style. Since it will take a week or so to get one from SPEC, I wanted to see if I could come up with an alternative.
I intalled a SPEC 2 (bought it barely used from a forum member last year) that did not have the shim from SPEC included. The pedal engages a bit too close to the floor for my style. Since it will take a week or so to get one from SPEC, I wanted to see if I could come up with an alternative.
