Couple of RAM Clutch???
Thread Starter
LS1Tech Sponsor
iTrader: (12)
Joined: Nov 2001
Posts: 14,865
Likes: 6
From: Bridgewater,Ma
Re: Couple of RAM Clutch??? Do the drill mod <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
I did not use any shims on my install.Works great.
I did not use any shims on my install.Works great.
Re: Couple of RAM Clutch??? No shimming required with a GM 145 slave cylinder. The drill out mod would be wise also <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
<small>[ December 22, 2002, 02:04 PM: Message edited by: Futral Motorsports ]</small>
<small>[ December 22, 2002, 02:04 PM: Message edited by: Futral Motorsports ]</small>
Couple of RAM Clutch??? First question is do i have to shim the slave cylinder any, if so where should i start at? I have the 402pp,910disk, and 1550 flywheel.
Second question i old a cartek adjustable master but it dosent have the drill mod, should I do it. I would think yes, but not sure.
Second question i old a cartek adjustable master but it dosent have the drill mod, should I do it. I would think yes, but not sure.
