Bent Rod In Master Cyl
#1
Launching!
Thread Starter
iTrader: (7)
Join Date: Nov 2006
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Bent Rod In Master Cyl
Ok so i put in a new RAM clutch and go to put the clutch in, and it stays on the floor. I manually pull it back up and the pin pops out and is bent all to ****. What causes this? Just a bad MC or what? Have to replace the whole thing?
Car in sig btw...
Car in sig btw...
#3
TECH Addict
iTrader: (7)
While I'm not sure what could have caused this, it sounds like you'll be best off just getting a new master. If that rod was all bent, you don't know what the inside of the master looks like (or maybe you do) and I would think it's safer to just replace it than try to rebuilt when there could be other damage internally to the master.