Quicktime Bell housing
07-08-2008, 03:43 PM
#1
Quicktime Bell housing I did a search and haven't found too much on this. Has anyone installed this bell housing? Just curious if it was easier to install than everything I've been reading about the McCleod??
Seems to be SFI rated but not positive as the website says "Passed SFI testing"
Thanks
Seems to be SFI rated but not positive as the website says "Passed SFI testing"
Thanks
07-09-2008, 05:55 PM
#4
Staging Lane
iTrader: (8)
Join Date: Feb 2006
Location: Canal Winchester, Ohio
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Damn. Wish I would have known about this bellhousing a month ago. I've had a bitch of a time getting my McLeod bolted up. Initially it was hitting my driver side cat. So I bought and off-road y pipe. Just bolted that up last night and the bell still hits that. So, this morning I took the bell to a shop and had them grind some of that edge off. Hopefully it'll fit now. I'll find out after I get home from work tonight. I'm tired of dealing with this damn thing.
07-09-2008, 10:26 PM
#7
9 Second Club
iTrader: (9)
Join Date: Jan 2007
Location: Pittsburgh
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
put a quicktime in a vette. def a nice peice. had to grind a little to clear the Kooks long tubes but other wise a lot easier than mcleod.
but on another note any SFI bellhousing is better than factory IMO
but on another note any SFI bellhousing is better than factory IMO
