TransAm Mania

iTrader: (7)

I've tried searching and can only seem to find threads discussing how to remove the pilot bearing. What is the best way to install it?

Viper

iTrader: (6)

One of two.

1. - use a socket the same size and beat it in till it's flush
2. - use a race bearing install kit you rent from autozone; it won't destroy the face.

Project GatTagO

iTrader: (7)

Put the bearing into the freezer over night, then use method #1 or #2 listed above.

Andrew

toneloc60

iTrader: (7)

10th grade shop class taught me this is a no no, but I used two hammers. One on the face of the bearing while tapping it with another. Sometimes sockets leave marks.

smokeum99ta

iTrader: (15)

Bingo!!!!!!

ghettocruiser

iTrader: (17)

I used a socket to install my pilot BUSHING... Being softer it marked the face up a bit. But since the trans input shaft doesnt really ride on the face, I didnt think it was a big deal.

But your best bet is the race installer. I ALMOST didnt return that rent a tool set when I was done with it. I use it so much for doing rears and all. They come in handy.

J.