Thanks Miti Vac

Reply Subscribe

Thread Tools

Search this Thread

Aug 22, 2008 | 08:16 PM

ls1mn6_3

Thread Starter

Teching In

iTrader: (6)

Joined: Sep 2003

Posts: 27

Likes: 0

Thanks Miti Vac

Just finished a clutch and slave cylinder swap on my '99 Z28 and was having problems bleeding the air out of the hydraulic line. I followed some of the posts here and purchased a Mitivac. I just put the conical fitting in the reservoir hole and pumped up to 15 in. Some air started coming up right away, but the big bubbles came up when pumping the clutch. After about 20 pumps, we were done. No mess. No DOT 4 shower from below. Went for a drive and the pedal feels better than ever before. Thanks to everyone that recommended this method!

Aug 23, 2008 | 12:19 AM

7camaro7

TECH Resident

iTrader: (15)

Joined: Oct 2006

Posts: 910

Likes: 0

From: Tennessee

how much was it? and where did you get it?

Aug 23, 2008 | 12:34 AM

cammedss2000

Staging Lane

iTrader: (1)

Joined: Aug 2008

Posts: 67

Likes: 0

From: Charlotte

sounds like what I need. can you get it at autozone or something

Aug 23, 2008 | 07:57 AM

acceleration junky

Teching In

Joined: Feb 2008

Posts: 43

Likes: 0

From: Long Island

I just bought one from autozone. I could never find it on there website, but they have them by thier oem tool section. It was $35 with tax. The package says oem industrial vaccum pump on it.