Description:

These parts were used for approximately 50 miles before the ATK junk short block (Decked wrong from them) decided to impact my intake valve, break it and grenade the #3 cylinder. Putting a LY6 6.0L in my truck and don't need the parts any longer since my vehicle inventory is all LS now.

Asking $1000 for this as a whole and will consider reasonable offer's close to this price. I'd like to sell as a kit but if I can get buyer's for parts I will break it apart.

This kit will allow you to run a Drive By wire System (selling Edelbrock Pro-Flo Intake config separate from this add). This is done by using a GM ECU or Holley TerminatorX or Dominator.

120-00139, $870
Designed for SBC w/ Roller Cam, step nose and one piece seal engine
The above part encompasses the following 4 part numbers.
Billet Timing Cover - 120-00092 - $425
Double Roller Timing Chain w/ 4X on Cam gear 120-00069 - $240
Crank Position Sensor - 110-00005 - $45
Cam Position Sensor - 110-00052 - $45



Two Resonant Knock Sensor mounts - 120-00053 - Qty 2, $24 per
Two Resonant Knock Sensors - Qty 2, $20 per
Oil Pump Drive - Mallory 29003 - $150

120-00072 - Single Coil Pack mounts for Center Bolt valve Covers with bolt kit ($211)