235/243 cam, engine tools, degreeing stuff, rear lowering springs, 4 channel sensors
-
Price
$15
- Location Lancaster, PA, 17601, USA
Description:
https://ls1tech.com/forums/market/1920058
not sure if this link will work because its expired but all the pics are in here
all include shipping but not the 3% PayPal fee
KW springs from my variant 3 kit, these wouldnt work with my 9 inch rear, but seem to be deigned around a stock 10 bolt. the spring rates are roughly 135-140 pounds. includes the seats that allow you to adjust the ride height. $100 shipped
1 cloyes hex adjust cam sprocket from kit 9-3158A, for gen 3, has the 1 large cam sensor mark, this is nice because if you already have a good crank sprocket you dont have to waste money on an entire timing set or worry about pulling the lower pulley, very very low miles, also will include with it a BNIB sealed bearing that goes behind the sprocket, $60 shipped
crank sensor, should work for any 24T wheel but please check fitment, 12560228, 1 startup on sensor, $25 shipped
moroso crank sprocket for ls1 motors 55 shipped, also have 11 inch moroso degree wheel
4 channel abs sensors....they work.......$90 shipped
12596334 windage tray with tray with tube, unknown fitment, but it is a wet sump of some kind. $35 for both shipped
the nicer looking mobile 1 cap $15 shipped
235/243 cam, 260 shipped, here is the pics for that. cam card below https://ls1tech.com/forums/market/19162
some knowledgeable guys on here said due to the open and close events this cam would be good for a higher than stock compression motor, maybe somewhere 11.5 to 12.0 to 1
lifter bore dial indicator $45
alignment tools...front and rear...$50
deck bridge $20...I have one but why not?
LS2 timing cover $10
what about the other dial indicator?
send me your PayPal and pricing on other indicator via PM...
Anyway, got the stuff today. Quick delivery. Great pricing. Honest seller here guys.
Thanks again!
