Description:

I have an LS Swapped 1981 Chevrolet Impala coupe For Sale. Silver with powder blue interior. 90K miles on the body/ Frame. I bought this car last fall with the Ls swap already completed. Its a LQ4 iron block 6.0L with a 4L/80E transmission and a posi 3.42 10 bolt rear end. It retains the Factory A/C system, Has a Dakota Digital dash and Bluetooth radio. Everything is in good working order I just Installed new tires, front and rear shocks, rear springs, rally wheels with trim rings and center caps, new power steering pump and hardware. Motor has a mild camshaft and mid length headers with dual exhaust H-pipe and Flow master mufflers.

Ive put about 3000 miles on the car since i've had it with no issues. I do not have a dyno sheet or hp numbers but a cammed 6.0 with basic boltons should put down 350-400 rwhp. The car has been super fun and reliable! Overall i would rate the condition of the Vehicle a 8 out of 10. In my opinion it could use a new interior carpet and floor mats just kind of sun faded. New headliner has been installed. Any question feel free to give me a call. Below is a list of whats was done to the car from the previous owner when the swap was finished. Feel free to contact me for pictures and videos.

Thanks Steven
773-517-5622

LS2 6.0L Long Block
Comp Cams LSR Cathedral port LS2 269/277 607/614 Roller Cam #54-456-11
Motor mount plates by ESR Race
Aeromotive 13136 EFI Bypass regulator
Aeromotive 18688 phantom 340lphstealth in tank electric fuel pump kit
Stainless lines and fittings
Russell 640853 push on EFI fittings w/ 3/8" hardlines
13.4mm Braided hoses, separator clamps and fitting adaptors
ORB-6 O-ring, BOSS AN6-6AN adapter fittings
RSR Camshaft cover
RSR Timing chain kit
Summit Engine Piston/Bearing/Crank Kit
High Volume Oil pump, summit racing kit cover and gaskets
8 spark plugs
Cylinder head valve cover kit
Serpentine Belt
Dyno Tuned (3)
Exhaust short tube headers
Trick Flow Push Rods
Valve spring shims, Spring seats and keepers and retainers
Fuel filter
Dipstick
Custom Transm. Mount
ECM and Throttle body units
Fuse block assembly
IAC enabled ECM and parts
Digital dask kit with series 2 upgrade/calibration
Miscellaneous O2 sensors, exhaust clamps/gaskets, brake hoses, etc......
4L80E Transmission with shift kit built by Rhino Transmissions
Flowmaster mufflers with custom made exhaust
Custom fitted A/C system to fit car
Miscellaneous sensors/adaptors