WTB JAAM Ram Air Lower Deflector Plate
WantedMiscellaneous
Nov 1, 2021, 06:02 PM | Replies: 18 | Views: 1999
-
Price
Any Price
- Location O'fallon, MO, 63366, USA
- Condition Used
- Compatibility
| Make | Model | Year |
|---|---|---|
| Pontiac | Firebird | 1998 - 2002 |
Description:
Looking for a JAAM lower deflector/plate for my 99 WS6. Don't want the whole kit, but I am open to it. Honestly just want the plate to clean up the engine bay. Not too worried about price. Reply here or PM.
Thanks,
Coy
Last edited by Coy; Nov 1, 2021 at 06:52 PM.
If you can deal with a slightly different look a couple years ago I purchased a sheet of black 1/8" ABS plastic and made one of these myself, I was going more for functionality than looks but it doesn't look bad and it was easy to install.. just a thought.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
On the outer side edge where it lays against the bumper supports those tabs would be difficult
But if I can keep it as flat sheet with the bend at the bottom. That be supper simple would be even better if I could get them Lazer cut then fold but that might add cost. I wouldn't mind one either would keep me from painting stuff....
I'll see if I can template it out and what gauge metal is required
But if I can keep it as flat sheet with the bend at the bottom. That be supper simple would be even better if I could get them Lazer cut then fold but that might add cost. I wouldn't mind one either would keep me from painting stuff....
I'll see if I can template it out and what gauge metal is required
If I can make one would you guys be interested? I'm not surnoI can do the raised flaps with the seal on them, but I could make the flat part with holes fornthe latch and reservoir pretty easily I think.
I would also add that you could always do those side flaps with the seal as separate pieces that can be bolter or riveted on. Just a thought
Teching In
Joined: Nov 2024
Posts: 12
Likes: 1
From: Bay Area, CA
2025 - i'm interested in buying the lower deflector plate if anyone has one (and priced reasonably). That diverter plate reminds me of the one that comes in the RAISS ram air intake kit for the 94-96 impalas. I have that kit on my 96 SS and it does help with air flow.