Considering how loud it could of been...
Thread Starter
TECH Senior Member
iTrader: (8)
Joined: Jan 2007
Posts: 13,845
Likes: 0
From: Here and sometimes there too.
Considering how loud it could of been... I was a little worried how loud my truck was gonna be after re-building it and forgoing cats, resonators and mufflers. However after starting this thing up I'm happy to report that it idle's quite mellow for what it is, which is basically 4" DP with a 13" Bullets after the split and straight out. 
I've cleaned up some of the wiring since the video so it's not as ugly anymore, anywho here's and idle video and walk around.
http://www.youtube.com/user/Spoolini.../1/1cBthFI00Us
And a second one...
http://www.youtube.com/user/Spoolini.../1/1cBthFI00Us
I've cleaned up some of the wiring since the video so it's not as ugly anymore, anywho here's and idle video and walk around.
http://www.youtube.com/user/Spoolini.../1/1cBthFI00Us
And a second one...
http://www.youtube.com/user/Spoolini.../1/1cBthFI00Us
Niccce! sounds quite im doing a front bumper exit on my turbo build with these on eachside
http://www.madmanandcoracing.com/sho...spx?itemid=208
http://www.madmanandcoracing.com/sho...spx?itemid=208
Thread Starter
TECH Senior Member
iTrader: (8)
Joined: Jan 2007
Posts: 13,845
Likes: 0
From: Here and sometimes there too.
Those look pretty sweet LTXBOI. I still haven't decided what shape to make the plates, but those madman ring hoops look pretty good. I'd get them Powdercoated black probably but they look good. Thanks for the heads up.
Dyno run aborted at 4500rpms...
http://www.youtube.com/watch?v=RapBufmocDw
Dyno run aborted at 4500rpms...
http://www.youtube.com/watch?v=RapBufmocDw
Thread Starter
TECH Senior Member
iTrader: (8)
Joined: Jan 2007
Posts: 13,845
Likes: 0
From: Here and sometimes there too.
I have my speed sensor wires reversed in my tranny wiring harness, I have to hunt down that wire and swap it with the crossed wire. It's annoying because I can't do a crank re-learn because of that.
