Boring a nitro daves plate?
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: Jul 2008
Location: Cincinnati
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
Boring a nitro daves plate?
Is it possible to take my 70(?)mm nitro daves plate and have it machined to a 92mm? I kinda assumed the deals were the same just bored to different diameters?
Any aid or suggestions would be appreciated. Just sucks to sell it and go buying another one. I know it would just end up me getting another one out of pocket in the end. I cant really see it being really different.
Any aid or suggestions would be appreciated. Just sucks to sell it and go buying another one. I know it would just end up me getting another one out of pocket in the end. I cant really see it being really different.
#3
10 Second Club
iTrader: (38)
Join Date: Oct 2006
Location: Phoenix, Az
Posts: 1,259
Likes: 0
Received 0 Likes
on
0 Posts
Why would you even risk screwing up and expensive part like that? (unless you have access to a milling machine) the plate size is physically different and the bolt pattern.
Last edited by myfast70; 11-13-2008 at 06:52 PM.
#4
On The Tree
Thread Starter
iTrader: (5)
Join Date: Jul 2008
Location: Cincinnati
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
What part of my question made it sound like this was a diy quick job and i wasnt going to be using a milling machine?
Thanks for the response nitro dave. I figured there could be a possibility it would work. Guess not..
Thanks for the response nitro dave. I figured there could be a possibility it would work. Guess not..