My bad, sorry.

 

ya ya ya....back to the switch panels....

 

Dynotune is a sponsor, you would need to get the gauges from them. The switch and wiring to cycle between the various pressures you need to contact Lythropus and get the switch and wiring info from him. Lythropus did a great job with the layout for sure.

PM me if ya got any questions.

 

Right on, thanks a bunch. I have Dynotune's Fuel Pressure and A/F Ratio digital gauges from them. They are mounted in the A pillar and I might leave them there. I will be contacting you soon since it is snowy here and would be a great time to rewire my nitrous kit.

 

Here's mine

 

 

 

damn carlos that looks clean...I've seen pictures of your interior before in other sections, i didnt even know you had a nitrous system. fooled me!

 

heres mine, made by Beer. I just put it in this weekend.

 

what is that consle piece around your shifter from?

 

nahh it just sticks out like a sore thumb

 

bad picture but you get the idea. Yes, its real carbon fiber

 

Mine still in the works:

 

 

pretty cool, finally found someone who has more switches than my 7-sw panel, lol. where did you get the carbon fiber flat stock? or is it painted to look like carbon fiber?
Robert

 

Robert56: It is real carbon fiber :-) My shop TT Performance in Little Falls, NJ custom made the switch panel out of one piece of carbon fiber and put a support brace on the rear to reinforce it so it does not bend in the middle when you apply pressure on the switches :-)

9 switches total as you can see:

Top Row: ignition, starter, water pimp, fans

Bottom Row: line lock, nitrous master, nitrous arm, bottle heater, purge.

 

Beer panel thru DynoTune: