custom nitrous piston, check it out.
Thread Starter
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
custom nitrous piston, check it out. these are good for a 400+ shot according to Diamond. congrats to them on there service and quality. these only took 2 weeks to finish when i was told a month so i was suprised. the rods are good for 1000HP at 7500RPM according to Scat. cant say to much about there service but the quality is very nice.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo
Thread Starter
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
the pistons cost around $700 though Diamond and the rods were only $450, but after selling some parts i had and my $100 gift certificate from Diamond i didn't pay a thing. those are the deals i like.
vents, i have the same question about the cable. we both have money in it so holfully it can get fixed. i will really need it when i put this motor together.
bigmike, these are custom pistons since the stroke is odd and the ring land is lowered for more spray so no part number. they are also for 1/16, 1/16, 3/16 ring pac so i can just use regular off the shelf SBC rings.
vents, i have the same question about the cable. we both have money in it so holfully it can get fixed. i will really need it when i put this motor together.
bigmike, these are custom pistons since the stroke is odd and the ring land is lowered for more spray so no part number. they are also for 1/16, 1/16, 3/16 ring pac so i can just use regular off the shelf SBC rings.
Thread Starter
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
vents, that sux. when it gets back, i can go over to your house and tune it for ya. i am going to have similar problems when this motor is intalled. i was upset when it broke because i could not tune danials car. what compression ratio are you running. last time we tried tunning it, it was running around 930 on the O2s. what have you changed since then?
cool steve. 
Thread Starter
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
Originally Posted by BADZ
Must be nice, I paid 1000.00 for my Oliver rods and 885.00 for my JE Custom Racing Nitrous pistons, they were custom cut though...
