nitorus install question
nitorus install question I am in the process of finishing up my nitrous install and i have a few questions that i know are going to make me sound like an idiot but im confused about them. the first one is i purchased this kit http://nitrousoutlet.com/catalog/pro...5&product=3910, it is the direct fit kit that comes with pre-bent lines, how do you get the lines to stay in where they slide into the ports on the fuel and nitrous solenoids. My second question is the bottle heater kit i purchased the electrical conector that comes with the kit is completely dissembled and i do not know how to put it together. thanks for the help ahead of time.
Did you try the HSW &/or Nitrous outlet web sites they should have instructions on how to hook up the bottle heater.
http://www.harrisspeedworks.com/instructions/
http://www.harrisspeedworks.com/instructions/
wow, i didn't even think about them being compression fittings, thanks, and the heater kit i got from a friend its a hsw, the electrical connector is in pieces and needs to be assembled
Its easy. Strip the end of the wire to show about 1/4" exposed copper. Slide the green seal over the wire. Attach the metal connector using a pair of needle nose pliers to wrap the metal tabs around the wire. Solder, then slide the green seal slightly over the metal tab. Insert both metal tabs into the connector until you hear a click. Rotate locking flap down until it clicks. Shoot me an email, call or pm if you need more help. Thanks.
nick
nick
