In need of a N2O system.
In need of a N2O system. Ok First to tell what I am doing.
I am currently just doing single mods to the car and looking to see what kind of increase I can get.
The car is a 2001 Z28 with A crate LS6/4L80E and a 12 bolt rear. I want to put about a 150 shot on it.
But I also have a 408 that is almost ready to go in the car and I am needing the kit to be able to adapt it to around 200-250 shot.
So the kit needs to be able to go from 100-250.
Not sure if I should run a noozle or plate system. The kit will only be on the LS6 for a short time.
Any info and help will be grateful.
Tim.
I am currently just doing single mods to the car and looking to see what kind of increase I can get.
The car is a 2001 Z28 with A crate LS6/4L80E and a 12 bolt rear. I want to put about a 150 shot on it.
But I also have a 408 that is almost ready to go in the car and I am needing the kit to be able to adapt it to around 200-250 shot.
So the kit needs to be able to go from 100-250.
Not sure if I should run a noozle or plate system. The kit will only be on the LS6 for a short time.
Any info and help will be grateful.
Tim.
Last edited by t72ss402; May 16, 2010 at 05:09 PM.
Check out these kits.... Both companies make Outstanding Products and Have GREAT customer service. Give each a call and they will get you set up with Exactly what you need. I just picked the 90mm plate kits as examples.... would all depend on what type intake you put on the 408, on whether a plate or dual nozzles would be best......
http://nitrousoutlet.com/catalog/pro...3&product=1130
http://nitrousoutlet.com/catalog/pro...9&product=2529
http://www.harrisspeedworks.com/prod...cat=136&page=1
http://nitrousoutlet.com/catalog/pro...3&product=1130
http://nitrousoutlet.com/catalog/pro...9&product=2529
http://www.harrisspeedworks.com/prod...cat=136&page=1
Registered User
Joined: Feb 2010
Posts: 12
Likes: 0
http://www.nitrousexpress.com/produc...ils.php?id=757
This system is also upgradable to a dual stage if needed.
This system is also upgradable to a dual stage if needed.
I would really like to run a plate system. How ever I plan on running a Typhoon intake(96mm) so I would have to up grade the plate when I change the motor.
dnkynrbk, how often do you go to the track? If it would stop raining on fridays then I would make it down there.
dnkynrbk, how often do you go to the track? If it would stop raining on fridays then I would make it down there.
For your application there is no doubt that the best choice out there is our plate system for 200 and 250 unless going with our directport is an option. Since you state you plan to change intakes you can easily purchase what you need now and sell the plate off when you change intakes. Then we can custom build you a 96mm plate with the same technology that goes into our cnc plates.
Dave
Dave
Dave what will the cost of machineing a 96mm plate be? If it is more cost effective to run a Fast and just get a already made plate that may be a better route. The system I am looking for 100-250 shot, purge kit window switch, and what safety items that are recommended.
