Microedge + not working or configured right
Thread Starter
TECH Apprentice
Joined: Nov 2009
Posts: 367
Likes: 0
From: Kentucky
Microedge + not working or configured right I controller fires the progressive stage and then shuts off after about 2 seconds which is what my lean out delay is set to. I can turn off the progressive and all works fine. Do I have it configured wrong possibly? Any obvious things to look at?
Thx
Sarge
Thx
Sarge
Go though all of your gear lock-outs, any time delays, a/f shutdown etc....something is shutting the system down. You mentioned the lean out delay, what is it set to and what is your a/f at that point?
Nick
Thread Starter
TECH Apprentice
Joined: Nov 2009
Posts: 367
Likes: 0
From: Kentucky
I went to standard mode and did away with the prgsv settings and hits great now. Is it normal for like a second or 2 delay after triggering the TPS and the nitrous actually hitting?
Anyway feel free to call me. I'll PM you my number.
Thx
Sarge
Thread Starter
TECH Apprentice
Joined: Nov 2009
Posts: 367
Likes: 0
From: Kentucky
I talked to Matt at HSW and he stated their Microedge will only handle 20Amp Solenoids and the NX Nitrous noid is 33AMP.
So either I need to get a lesser amp noid from another vendor or change the NX magnet to a lower 8amp magnet.
It would have been nice to know this before hand but oh well. Nothing on HSW site about not being able to handle a certain amp noid.
So either I need to get a lesser amp noid from another vendor or change the NX magnet to a lower 8amp magnet.
It would have been nice to know this before hand but oh well. Nothing on HSW site about not being able to handle a certain amp noid.
