200 shot for 1st time !
Thread Starter
TECH Apprentice
iTrader: (16)
Joined: Dec 2010
Posts: 307
Likes: 0
From: Mesquite, Tx
Thread Starter
TECH Apprentice
iTrader: (16)
Joined: Dec 2010
Posts: 307
Likes: 0
From: Mesquite, Tx
Thats was just leaving off the trans brake he didnt hit the spray yet. And if u have a 12 bolt as your sig says then i would hope it would hold. Any how he will take his money somewhere else no prob. Next time he is out there you should run him.
Ya it has a 12 bolt, we gota move 300+ pounds more then you. Stock drive shaft. We will run him any time he wants to get his *** drug
Btw weve been 1.3x 60' on a 10 bolt at 3400ish pounds.
Btw weve been 1.3x 60' on a 10 bolt at 3400ish pounds.
I will say this though, if he does get the bugs worked out of his car that cars going to be one hard car to beat…
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
TECH Resident
Joined: Jan 2009
Posts: 869
Likes: 0
From: In the moment...
Im not surprised the stock driveshaft broke before the rear but once that 12 bolt is in and a nice steel driveshaft its going to roll. As far Daniel's brothers car, that **** is a beast at full weight. Not sure if its street driven anymore but when it had the 4l60e it had to be one of the better sleepers in Dallas.
Thread Starter
TECH Apprentice
iTrader: (16)
Joined: Dec 2010
Posts: 307
Likes: 0
From: Mesquite, Tx
Yea i have heard it runs 6.40's or so which is awesome. I think he has a fooger on it with a stand alone if its the same system daniel use to run. Any how my car is dead hooking now which is good, but bad for the 10 bolt. If the rear last a few passes it will make a good number. I was told my car would never run a 10.xx on motor by daniel although it ran a 6.9x on motor at k dale not sure what that is in 1/4. But the car was different than. All's i can say is well see. 2700 pounds and 600ish on spray it better do something
My car never ran 6.4s. My car is slow. Daniel never had a fogger on his car. My car is still street driven, not as much as I would like to. My work schedule wont allow me to bring it out friday, but we will be out saturday. Your car will be fast @2700 and 600hp
Lemme correct u...i told u wat your car would run and it ran that exact number...a 6.9 would b an extremely low 11...maybe high 10...the grn car is only missin ac/heat...id jump in it n drive to mexico no hesitation...also dead hooking is way better then not...at that power and weight you should be low low 9s or high 8....just for kicks what does it 60 on motor and wat gears?
Lemme correct u...i told u wat your car would run and it ran that exact number...a 6.9 would b an extremely low 11...maybe high 10...the grn car is only missin ac/heat...id jump in it n drive to mexico no hesitation...also dead hooking is way better then not...at that power and weight you should be low low 9s or high 8....just for kicks what does it 60 on motor and wat gears?
He thinks his car weighs 2700... Im going with 2900.. 2950 lbs.. He's put **** back in the car that doesn't need to be in the car.
Your cars not slow your just dialing it in lol
Last edited by SSHAWK; Oct 13, 2011 at 01:04 PM.
Thread Starter
TECH Apprentice
iTrader: (16)
Joined: Dec 2010
Posts: 307
Likes: 0
From: Mesquite, Tx
my lt1 car weighed like 2950 with haeavy *** zr1's and this car has waaayyyy more **** taken out, full chromoloy k member and upper/lower arms, the th350 and 8 inch converter, he did put a fiberglass hood but its as heavy as the stock ss hood was imo cuz its a bolt on hood, i have him talked into lettting me take more weight out now like i want, only thing that sucks now is the heavy hood the vfn i wanted was 14 pounds and u delete the hinges ect... so big weight lose. Were going to cut out the t top hump, and both wells and i got some more ideas. he added the nitrous stuff after it was weighed and this weight was with both stock seats and we got a kirkey that will go in on race day. He just likes the stock look better than me. this was w/o him so 2900ish race weight
Like I said above 2900.... I don't care what the car weighs without him in it I'm not racing a empty car lol
But knowing you ...I bet you have a **** ton of stuff about to be removed out of this car lol
Make sure to take a video of the first pass.... Ask him to let you run it first and Tell him you will do a run like I did so you don't break the rearend on the first pass.
Then at the end of the night if he wants to try his way he can have at it.
But knowing you ...I bet you have a **** ton of stuff about to be removed out of this car lol
Make sure to take a video of the first pass.... Ask him to let you run it first and Tell him you will do a run like I did so you don't break the rearend on the first pass.
Then at the end of the night if he wants to try his way he can have at it.
Thread Starter
TECH Apprentice
iTrader: (16)
Joined: Dec 2010
Posts: 307
Likes: 0
From: Mesquite, Tx
Like I said above 2900.... I don't care what the car weighs without him in it I'm not racing a empty car lol
But knowing you ...I bet you have a **** ton of stuff about to be removed out of this car lol
Make sure to take a video of the first pass.... Ask him to let you run it first and Tell him you will do a run like I did so you don't break the rearend on the first pass.
Then at the end of the night if he wants to try his way he can have at it.
But knowing you ...I bet you have a **** ton of stuff about to be removed out of this car lol
Make sure to take a video of the first pass.... Ask him to let you run it first and Tell him you will do a run like I did so you don't break the rearend on the first pass.
Then at the end of the night if he wants to try his way he can have at it.
Tell him I will video his runs for him.
Well it was a good run
ProTreeRacing....... Racing green94z car vs Skeeter99 SS
Both will be posting up videos of the runs.
Both cars wheels came up..
In the end green94z car won... His car did very well.
Skeeter99's car ran very well for what it has.
ProTreeRacing....... Racing green94z car vs Skeeter99 SS
Both will be posting up videos of the runs.
Both cars wheels came up..
In the end green94z car won... His car did very well.
Skeeter99's car ran very well for what it has.
Our video is bad for some reason...it figures...i hope skeeter has it...our video shows the driver front wheel still up 30 feet out...was a good night...glad we could help you guy with the overflow and tire pressure to make the car work...it will fly with the bugs worked out...just stick with it