Nitrous Oxide Installation | Tuning | Products
Sponsored by:
Sponsored by:

having a problem with nos mini working...

Thread Tools
 
Search this Thread
 
Old Oct 9, 2011 | 11:30 AM
  #1  
vbls's Avatar
Thread Starter
TECH Apprentice
iTrader: (17)
 
Joined: Dec 2010
Posts: 398
Likes: 0
From: Virginia Beach
Default having a problem with nos mini working...

everything is hooked up right, it lets me go through all settings, and even sayd END when its over, but after the end it shows rr, and does not work...
any ideas?
Reply
Old Oct 9, 2011 | 12:00 PM
  #2  
vbls's Avatar
Thread Starter
TECH Apprentice
iTrader: (17)
 
Joined: Dec 2010
Posts: 398
Likes: 0
From: Virginia Beach
Default

well i got it to say CH1, but when i arm it, it starts spraying, it doesnt wait until 3,000 rpm and thats where i have it set at... any ideas on this?
Reply
Old Oct 9, 2011 | 04:27 PM
  #3  
IH8FORD's Avatar
10 Second Club
iTrader: (6)
 
Joined: Mar 2007
Posts: 952
Likes: 0
From: Fuquay Varina, NC
Default

Originally Posted by vbls
well i got it to say CH1, but when i arm it, it starts spraying, it doesnt wait until 3,000 rpm and thats where i have it set at... any ideas on this?
Did you go through all the steps and set up the proper setting for individual coil per cylinder
Reply
Old Oct 10, 2011 | 05:19 AM
  #4  
vbls's Avatar
Thread Starter
TECH Apprentice
iTrader: (17)
 
Joined: Dec 2010
Posts: 398
Likes: 0
From: Virginia Beach
Default

Yea I got that right.
Reply
Old Oct 18, 2011 | 01:13 PM
  #5  
99articfrc's Avatar
Teching In
 
Joined: Mar 2011
Posts: 14
Likes: 0
Default

Make sure both channels are set the same u may have it hooked up under chan 2

An make sure u hav the settings right with directions
Reply




All times are GMT -5. The time now is 12:35 PM.