two questions...

Reply Subscribe

Thread Tools

Search this Thread

Mar 12, 2004 | 09:53 PM

NOTFAST

Thread Starter

11 Second Club

iTrader: (10)

Joined: Aug 2003

Posts: 932

Likes: 0

From: Bel Air, MD

two questions...

i have a small leak where the fitting goes into the nitrous filter...tried to tighten it down more, but it wont go...can i just fill around the fitting with teflon paste? it looks like there was paste on the part of the fitting that is in the filter anyway...

2nd question - is it possible for a 3000 MSD window switch pill to go bad or something? I tried a 3000 and it didnt work, but the 3200 did. Anyone have experience with this? the 3000 also was loose in the window switch, while the 3200 fit snug.

thanks

Mar 13, 2004 | 10:32 AM

NOTFAST

Thread Starter

11 Second Club

iTrader: (10)

Joined: Aug 2003

Posts: 932

Likes: 0

From: Bel Air, MD

Ttt--

Mar 13, 2004 | 11:01 AM

EVIL

11 Second Club

Joined: Nov 2001

Posts: 1,645

Likes: 0

From: Hanover MD

the more you tighten those fittings, the more they leak. you are supposd to snug them. you can use to paste or tape to seal it.

i would just get a new 3000 pill and see if it works.

Mar 13, 2004 | 11:51 AM

NOTFAST

Thread Starter

11 Second Club

iTrader: (10)

Joined: Aug 2003

Posts: 932

Likes: 0

From: Bel Air, MD

thanks brian...

i figure im just going to pull the fitting out...check it out, and then put new tape in there and "snug' it...

i also found out resister can go bad...damn, i was hoping for those 11's last night, not to look like a fool running a 17 and then a 12.9 supposidly spraying...lol

Reply Subscribe

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
1 / 1
Next
Last