Direct Port question on Fast Intake
Thread Starter
12 Second Club
iTrader: (14)
Joined: Nov 2003
Posts: 286
Likes: 0
From: Kansas City, Missouri
Direct Port question on Fast Intake Are the direct port locations the same on a Fast 102 as on a Fast 92? I have a direct port setup with hard lines and I was seeing if I can switch from a Fast 92 to a Fast 102 without having to have new lines made?
Rusty
Rusty
8 Second Club
Joined: Aug 2007
Posts: 160
Likes: 0
From: Statham,Ga
Are you running cathedral port heads or rectangular port heads?
8 Second Club
Joined: Aug 2007
Posts: 160
Likes: 0
From: Statham,Ga
The base of the cathedral port manifold is very thick and requires deep counterboring
of the bosses to get adequate nozzle tip projection....or....you can purchase
the new long reach nozzles from Dave @ Nitrous Outlet.
When we went from the Fast 90 to the 102 we also went from a (2) solenoid system to a (4) solenoid system.
So...although I don't have an accurate way to answer your question, I would say,
be prepared to fab new hard lines.
of the bosses to get adequate nozzle tip projection....or....you can purchase
the new long reach nozzles from Dave @ Nitrous Outlet.
When we went from the Fast 90 to the 102 we also went from a (2) solenoid system to a (4) solenoid system.
So...although I don't have an accurate way to answer your question, I would say,
be prepared to fab new hard lines.
Thread Starter
12 Second Club
iTrader: (14)
Joined: Nov 2003
Posts: 286
Likes: 0
From: Kansas City, Missouri
From the pictures I've seen comparing a 92 to a 102, it looks like the ports are in the same general locations. I'm not sure if mine has the long reach nozzles or not.
This is what mine looks like:
Rusty
This is what mine looks like:
Rusty
