Nitrous Oxide Installation | Tuning | Products
Sponsored by:
Sponsored by:

New Dyno with N20

Thread Tools
 
Search this Thread
 
Old Sep 20, 2002 | 05:32 PM
  #1  
Ed Blown Vert's Avatar
Thread Starter
11 Second Club
20 Year Member
Photogenic
iTrader: (2)
 
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Default New Dyno with N20

In the sig. I ran a bit lean 13.5. N/A was 12.2
Might have to switch to wet to richen it up.

I was shooting for 400 rwhp.

<small>[ September 20, 2002, 11:30 PM: Message edited by: Ed LS1 Vert ]</small>
Reply
Old Sep 23, 2002 | 05:37 PM
  #2  
383LQ4SS's Avatar
TECH Veteran
iTrader: (33)
 
Joined: Nov 2001
Posts: 4,266
Likes: 0
From: Port Richey
Default Re: New Dyno with N20

Get some headers on that puppy...or atleast a cutout. Youll pick up alot with good exhaust mods.
Reply
Old Sep 23, 2002 | 09:46 PM
  #3  
Ed Blown Vert's Avatar
Thread Starter
11 Second Club
20 Year Member
Photogenic
iTrader: (2)
 
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Default Re: New Dyno with N20

Isn't a Borla wide-open about the same as a cut-out?

And yes headers would help alot. Don't think I will go that route yet.
Reply




All times are GMT -5. The time now is 08:03 PM.