NX Switch Panel
Thread Starter
TECH Apprentice
Joined: Jun 2002
Posts: 301
Likes: 0
From: Fayetteville, NC
NX Switch Panel Is there anyone else out there with one? I think the lowest about this panel and I can't wait till SLP day, here in Las Vegas Oct. 12th to show everyone. My switches somehow don't allow full voltage through the switches and it is about 1/8" too small. It won't clip into my hole it moves all around and sits out of the hole. When I called and spoke with NX about it. All they would say was, "I don't know what is up with your car, but I have three Camaro's in the parking lot and it fits fine in all of them. Well my stoch box clips right in and the convert. switch panel clips right in, but the NX is too small and NX won't even help. They have got to be the worst shop I have ever dealt with. I have had so many questions and problems with the whole setup and they have been useless. **** the kit is even missing two pieces and they'd rather argue and belittle me insted of just sending me the parts. To anyone wanting an NX kit, go TNT!
Scott
Scott
Thread Starter
TECH Apprentice
Joined: Jun 2002
Posts: 301
Likes: 0
From: Fayetteville, NC
Re: NX Switch Panel Did you tap the TPS switch directly to the throttle position sensor? I tapped into the blue of the three wire sensor on the side of the throttle body. Should I do it somewhere else? I cannot get a red light at WOT. I am trying by turning the key totally forward, just not starting the car. If I use a muptimeter, I get 4.5V at WOT, but I can't get a red light. It is driving me crazy.
TECH Resident
Joined: Mar 2002
Posts: 770
Likes: 0
From: WA
Re: NX Switch Panel My switch panel also fits loosely and for some reason I can't get the Activation/Bottle heater switch to work right. The light come on but no power to Noids or Heater.
Purevilss, Once you get it working, your going to be glad you got the MAF systeme.
Purevilss, Once you get it working, your going to be glad you got the MAF systeme.
TECH Apprentice
Joined: Aug 2002
Posts: 377
Likes: 0
From: Anderson IN
Re: NX Switch Panel if i remember right i tapped into the blue wire with a gray stripe coming off of the tps. i had to kind of play with the adjustment on the tps switch, it did not work exactly like the instructions.
