few detail questions..
Thread Starter
12 Second Club
Joined: Jun 2012
Posts: 1,548
Likes: 1
few detail questions.. ok, mid install, and have few more detailed questions..as once ur elbow deep the instructions leave out certain angles..
1- what are u guys setting the fpss at? comes preset at 35psi it says..is that a safe point to run, or shud i adjust any.
2-filter, right after bottle, or right before solenoid? i was thinking right after bottle, to keep main line clear of crap..
3-can anyone give me a good checklist to go over before first spray, not the typical check all connections, real world checks that save u from disaster..
1- what are u guys setting the fpss at? comes preset at 35psi it says..is that a safe point to run, or shud i adjust any.
2-filter, right after bottle, or right before solenoid? i was thinking right after bottle, to keep main line clear of crap..
3-can anyone give me a good checklist to go over before first spray, not the typical check all connections, real world checks that save u from disaster..
If its adjustable I'd turn it up to a lil under where your going to be running it. Maybe 5lbs. Im not a high pressure guy so i don't know how much it can flucuate on initial hit. Might have to watch it to see on initial hit that it doesn't dip down to low and try and shut your system off. Before hooking up the mainline to the noid, turn the bottle on a Lil to blow anything that might be in the line out. And it's a good idea to try the system before actually taking it out, leave the bottle off, hit the kit to make sure the noids are working properly. Turn the bottle on and chk for leaks around the fittings. Good luck.
