LS1TECH - Camaro and Firebird Forum Discussion
LS1-LS2-LS3-LS6-LS7 PERFORMANCE
Nitrous Oxide
Using a gauge, nitrous line, and fuel COS

Nitrous Oxide Installation | Tuning | Products

Sponsored by:

Using a gauge, nitrous line, and fuel COS

Reply Subscribe

Search this Thread

Old

Jan 18, 2015 | 07:21 AM

#1

Thread Starter

11 Second Club

iTrader: (8)

Joined: Jan 2011

Posts: 346

Likes: 1

From: Pen Argyl, PA

Default

Using a gauge, nitrous line, and fuel COS

Hi all,

Need some help finding a fitting that will work with my fast fuel rails so I can run a gauge, fuel cut off switch, and the line for my wet shot. The fuel line for the wet shot is 4an. See picture attached. Thanks

Attached Thumbnails

Using a gauge, nitrous line, and fuel COS-wp_20150116_015.jpg

Old

Jan 18, 2015 | 04:52 PM

#2

Thread Starter

11 Second Club

iTrader: (8)

Joined: Jan 2011

Posts: 346

Likes: 1

From: Pen Argyl, PA

Default

got it, going to use Russell 670290 to connect to the Male side of the the existing black fitting, put my gauge in the front where the fuel pressure switch is currently and put the fuel pressure switch in the Russell 670290.

Old

Jan 19, 2015 | 09:13 AM

#3

Ls1tech & Truck Sponsor

iTrader: (4)

Joined: Jun 2010

Posts: 2,267

Likes: 1

From: Wichita falls Texas

Default

Quote:

Originally Posted by 1slowbusa

got it, going to use Russell 670290 to connect to the Male side of the the existing black fitting, put my gauge in the front where the fuel pressure switch is currently and put the fuel pressure switch in the Russell 670290.

Yeah I was going to say that, or put another swivel manifold on there, or some kind of "t".

Good luck.

-Garrett

Old

Jan 19, 2015 | 03:24 PM

#4

Thread Starter

11 Second Club

iTrader: (8)

Joined: Jan 2011

Posts: 346

Likes: 1

From: Pen Argyl, PA

Default

Thanks Garrett.

Reply Subscribe

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 02:15 PM.