Replacing my 5177 noids with...
Replacing my 5177 noids with... A Iceman noid. Anyone done this?
I think the jetting will be different but it shoud work fine right?
I am also goona move the noid closer to the lid so there is less lag and it hits faster off the line.
Any info would be a big help ...Thanks
I think the jetting will be different but it shoud work fine right?
I am also goona move the noid closer to the lid so there is less lag and it hits faster off the line.
Any info would be a big help ...Thanks
The jetting shouldn't change at all, the jet is what controls the amount of flow of nitrous through the jet, not the noid. The only way that your jetting would change at all would be if the noids that you swapped to had a smaller orifice size than the jet you wanted to run. If that happened you wouldn't be able to make the claimed power of that jet.
