Does anyone know where a good place to plug into the TPS wire is for a clean install? TIA

 

I usually tap the wire near the TB. Then run it through the factory harness over the motor.

 

Another option would be at the PCM (Red Connector on PCM, pin 24, Dark Blue Wire).

Matt

 

No cutting or splicing required.

Caspers Electronics is making me a plug in wiring harness for my Z06 with a pigtail for the TPS wire. Justin over there was great to work with.

I will then put a single wire GM weather-pack connector on the pigtail.

 

Now thats pimp..
Dave

 

Dave: I told you Carper's has some neat stuff. Don't give up on me yet. I'll get this nitrous set up going one of these days. Actually I am getting pretty close.

 

Terry,
Yes I have been meaning to check them out. Ill put it oin my to do list.
When you spray it will be all worth it..
Dave