Nitrous wiring questions.
#1
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Sep 2004
Location: Mustang, Ok
Posts: 1,332
Likes: 0
Received 0 Likes
on
0 Posts
Nitrous wiring questions.
I looked at the diagrams in the sticky thread and the collors are different than the relay I have. The relay I have has red, blue, green and orange wires. The relay in the sticky thread shows black, green, white and red. I bought the kit used but it was near new and supposedly the original supplied relay from the 5177 kit. Also, where would I hook up the tach signal wire from the window switch on an 01 SS?
Thanks for the help guys!
Thanks for the help guys!
#3
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Sep 2004
Location: Mustang, Ok
Posts: 1,332
Likes: 0
Received 0 Likes
on
0 Posts
The relay is numbered like this... 87, 87a, 86, 85, 30
Could I have the wrong relay, the set up worked on the last car just fine.
As you can see I am no ellectrical expert, thanks for the help!
Could I have the wrong relay, the set up worked on the last car just fine.
As you can see I am no ellectrical expert, thanks for the help!
Last edited by Jeremiah; 07-09-2006 at 01:18 PM.
#5
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Sep 2004
Location: Mustang, Ok
Posts: 1,332
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Matt@HSW
What wiring diagram are you using? A few of them have pin numbers along with the colored wires. Let me know anf I'll try to help ya.
Matt
Matt
This is the one I have been looking at in the nitrous related wiring sticky. I have the 5177 kit with the MSD window switch and FPSS. I have everything wired as in the diagram but not sure about what pins to tie into on the relay.
Sorry for the small picture, its the best I can do as I am an idiot on computors.
Thanks Matt!