NX Pro Flow valve
not hard at all...you just need a big wrench and a good way to secure the bottle to stop it from spinning
my brother and I, both of average size, were able to get the old valve off and put the new one in. he held the bottle and i did the wrenching
i think it was 96 bucks for the valve w/gauge
my brother and I, both of average size, were able to get the old valve off and put the new one in. he held the bottle and i did the wrenching
i think it was 96 bucks for the valve w/gauge
I wrapped an old accessory belt around the bottle, stepped on the belt for tension, using a 10" Adj Wrench and took the valve off, thread sealant on new valve threads, install and tighten. Cost, look on Nitrous Dave's Outlet or NX website, or of course pm Nitrous Dave.
