Autometer Nitrous Sender (Electric)
Thread Starter
Launching!
iTrader: (6)
Joined: Oct 2005
Posts: 282
Likes: 0
From: Corpus Christi, Texas
Autometer Nitrous Sender (Electric) I bought the Autometer nitrous pressure sender (pn 2240) and am planning to use my Interceptor scan gauge for the analog input for the reading. I didn't buy the wiring harness because, well I'm cheap, and it's $35 that I didn't think I would need to spend. Now my problem is knowing which terminal on the sender is which. Which one gets the +5V input, which is grounded, which is the output? Anybody that has this sender (I think they're fuel pressure sender has the same setup) help me out please..
Thanks
Thanks
Actually I just woke up remembered something... that picture I drew was of me testing the power coming out of the harness from AutoMeter. So if you're looking down into the pressure sender, flip the + and - ! Ground will be on the left and power on the right, signal will still be in the bottom middle. I'm not sure that it'll make a difference, but it could.
