N20 wet kit placement
Thread Starter
12 Second Club
iTrader: (7)
Joined: May 2006
Posts: 105
Likes: 0
From: Southampton, NJ
N20 wet kit placement Ok I have been in cars with N20 systems and driven them, but I have never owned or installed a kit. I recently bought a wet kit off a fellow Ls1techer here and I have read alot of post about the angle and posistioning of the nozzle. I am wondering where would it be best for me to install the nozzle and what angle it should be at, does it make a difference where to mount the selonoids? I know some people want to rip me apart for being a noob and other might say don't do it cause i don't know what im doin, but i spent the money and you can't learn if you don't try... So wrap up is I would like to know where to mount nozzle for optimum performance, where to mount selonoids, and where do u take the fuel feed off of to run a wet kit? Any information that can be provided is greatly appreciated, I just dont have the 300-450 it costs for local shops to insall this for me
TECH Fanatic
Joined: Oct 2005
Posts: 1,131
Likes: 76
From: olympia, wash
I mounted mine into the bellow's at a 3:00 position facing the tb. Some mount their's at the 5:00, but either one should be alright.
As for getting the fuel feed, you could run a ''T" off of the fuel line, or even better, take the cap off of the driver's side fuel rail, remove the schrader valve and put in a 1/16NPT to -4AN fitting,[included in most wet kits] for a real nice and clean looking install.
Sounds a lot more difficult then it is, but it's maybe a 10 minute job.
As for getting the fuel feed, you could run a ''T" off of the fuel line, or even better, take the cap off of the driver's side fuel rail, remove the schrader valve and put in a 1/16NPT to -4AN fitting,[included in most wet kits] for a real nice and clean looking install.
Sounds a lot more difficult then it is, but it's maybe a 10 minute job.
