I have made sure that all the wires are correct and I have checked to make sure I have power going to the heater and it is and now the heater just doesn't seem to be heating up....... I got this heater second hand BUT the thing I am worried about is...... I have the green wire going to the heater and then the green wire(from the relay and then the pressure switch or whatever it is) ties into the two white wires into the bottle. Should one of those white wires be tied in as a ground or are both power wires?

Josh S.

 

go to nitrousexpress.com over on the right of the page about half way down their is a link that says product installation instructions. it shows the wire diagram! make sure your getting a good ground that was my biggest problem!! good luck!

 

ONe of the white wires is a ground