installing a buddy's nitrous system today. drilling/pluming for the nozzle on the left side of the air lid. which direction should i aim the nozzle (toward the maf/engine side or toward the front of the car so it disperses better first? i've seen ls1s put 2 nozzles on (split to one on each side) is this better or is just putting one on one side ok?

 

its a dry kit right? just trying to make sure becuase if it is a wet kit then it cant go in the lid

 

i think you're the same guy that posted this ? on z28.com. anyways, here's how i did mine. forgive the crappy cell phone pic. batteries were dead in the canon. i haven't sprayed it yet to see how it works because i have a custom n/a tune and need to pull some timing first.

 

aim the spray so it hits the maf wires

 

Hey Hallass.where did you get the clear lid? I gotta have one!

 

MTI. they're a site sponsor. Zach@MTI is the member name you want to pm about getting one.

 

LMAO @ that sticker on your lid. Where did you get that?

 

i actually think i got it off of some jeep website years ago. i have another one around here somewhere but can't remember where the hell i put it. that seemed like a good place to put this one though

 

This IS a dry kit, right? If it's a wet kit, you prob want to think about placing the nozzles behind the MAF from what I have been reading and seeing.