guys i have a tnt f1 100 wet shot and have a fast 90/90 setup on my 2002 z06 i pulled the power ring off the 78mm tb that was used in my friends ta...this power ring just barely fits over the 90tb and leaves about 1/2 inch exposed at the base of the tb basically i am saying that there is a very small gap on the inside of the tb and power ring maybe 2mm between the insulation in power ring and edge of tb,,,my question is (and keep in mind this tb is goin NOWHERE i really hammered it on there) will this cause a disaster when sprayin will nitrous pool in this gap? would it really be that big of a deal i cannot see mechanically why it would be bad unless the tb fell off lol but the nozzles are pointed straight at the tb blade so i dont see a prob i will be installing on fri ANY ADVICE WOULD BE GREATLY APPRECIATED thanx guys

 

Need a pic. sounds kinda Mickey Mouse to me. Why would you want to choke your 90mm TB down with a 78mm ring? or am I missing something?
Robert