slp mass air and a dry kit

Reply Subscribe

Thread Tools

Search this Thread

Jun 30, 2003 | 04:56 PM

n2o

Thread Starter

TECH Enthusiast

iTrader: (1)

Joined: Jan 2003

Posts: 702

Likes: 0

From: Saban Country

slp mass air and a dry kit

Hello all I bought a 85mm slp b/c it was cheap and i am wonderig if it would be ok to spray through it. It increases timing like 1 or 2 degrees. Also how high can I go without it causing me problems, but if I need to go with the stocker I will.

Thanks

Jun 30, 2003 | 06:41 PM

00 Firehawk

Launching!

iTrader: (1)

Joined: Jul 2002

Posts: 228

Likes: 0

From: Springfield, Illinois

Re: slp mass air and a dry kit

I use a SLP Maf and spray through it (175 shot). Make sure that your nozzle is at least 6" from the Maf and you should be fine.

Jul 1, 2003 | 06:12 AM

scalemaster

10 Second Club

iTrader: (3)

Joined: Feb 2003

Posts: 1,090

Likes: 0

From: Pearland,Tx

Re: slp mass air and a dry kit

is it ok to take the screen out of the 85mm maf
from slp or will it be a problem

Jul 1, 2003 | 11:25 AM

00 Firehawk

Launching!

iTrader: (1)

Joined: Jul 2002

Posts: 228

Likes: 0

From: Springfield, Illinois

Re: slp mass air and a dry kit

Mine is descreened and I have had absolutly no problems.

Jul 5, 2003 | 11:21 AM

Jpr5690

TECH Junkie

iTrader: (13)

Joined: Nov 2002

Posts: 3,806

Likes: 0

Re: slp mass air and a dry kit

for what your doing theres no reason to descreen it and by descreening it you may get problems cause this allows the air to flow turbulently past the sensor and does not allow for accurate readings slp does not reccomend descreening the maf unless you are pushing more than 650 hp from what i here but then again some do it and have no probs at all i can just say theres a risk involved and no gain for your setup (IMO)

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last