Purge Nozzle
Thread Starter
TECH Resident
iTrader: (7)
Joined: Jul 2003
Posts: 756
Likes: 1
From: Southern Indiana
Purge Nozzle Im recently installed a TNT F2 kit on my H/C LS1. I also ordered the tnt 4an pro purge kit. Im wanting to somehow split the purge into two lines and run one out each side of where the windshield whipers lay. What kind of distribution blocks or whatever will i need, and where can i find the actually nozzles to put on the end of the lines so the purge will be very powerful.
Re: Purge Nozzle Easiest way is go to Eagle Hardware. Go to plumbing section where they have all the fittings and find a -4an to I believe a 1/4" fitting. From that you can find a T that will split your line. I also ran steel braided line for the purge. I also got those from a plumbing store. They are high pressure lines used for refrigerators I believe. They have 1/4 connectors so they will screw right on. Most everyone just uses copper tubing for the end of their purge setup. Crimp the ends and it should give you a nice spray.
Re: Purge Nozzle Check out http://www.dynotune.org they have a billet aluim purge nozzle that is really trick and only cost 20 or 30$$.
