Going with a 6.0 block with forged pistons and rods with a stock crank. 11.1 compression. ARP bolts every where and my GTP st 2 heads and tr224 cam. I will be haveing a th400 with PY3600 installed. SO how big of a wet shot could i use on that motor.

 

At least a 350 shot. I have a similar setup except with a aluminum LS1 block plan on going at least to that amount. With the 6.0 block I would hesitate to go with at least a 350 shot. The key is a kick *** fuel system. When it comes to that, don't take any shorts!

 

Going with sumped tank with complete aermotive fuel system.

 

Hey Jeff, good luck with the new set up. Spray 300 at that thing and never have a worry about losing