1999 z28 roller
#1
1999 z28 roller
How would you repair the bolt hole for the k member on the driver side it's rusted out and thats the only rust on the car so I would not be able to bolt the k member up to hold the engine. Thanks any help will be appreciate if not allowed delete
#2
11 Second Club
iTrader: (3)
I'd say you would need to cut a square section of steel out of the k-member and weld a similar size and thickness of steel there and then drill and tap new threads. That is if we're talking about the k-member itself and not the through hole mount that bolts to the k-member.
The following users liked this post:
Marcus Mitchell (05-04-2021)
#3
I'd say you would need to cut a square section of steel out of the k-member and weld a similar size and thickness of steel there and then drill and tap new threads. That is if we're talking about the k-member itself and not the through hole mount that bolts to the k-member.
#5
11 Second Club
iTrader: (3)
The following users liked this post:
kyphur (07-14-2021)