Mini Tub Thoughts
Thread Starter
Teching In
Joined: Mar 2006
Posts: 41
Likes: 0
From: Heflin, Alabama
Mini Tub Thoughts So I'm in a bit of a predicament... I purchased a mini tub kit a few years ago and just now getting around to installing it. They are labeled fbody drivers and passenger sides and pinch joint already bonded. The problem is, the driver's side seems to be best fit for both sides. I possibly can get passenger side to work on driver's side with trimming. I can provide pictures if y'all need a visual of the issue.
Looking to see if anyone else has faced this problem before. I feel I have 3 possible options.
1. Trim until I get a somewhat close fit and fill in any areas that doesn't match up.
2. Attempt to remove the pinch joint and find where the problem truly is. Then continue from there, assuming I can reattach the pinch joint.
3. Just buy another kit. Not really a fan of this option but rather have it done properly than piecing stuff together for "good enough"
Looking to see if anyone else has faced this problem before. I feel I have 3 possible options.
1. Trim until I get a somewhat close fit and fill in any areas that doesn't match up.
2. Attempt to remove the pinch joint and find where the problem truly is. Then continue from there, assuming I can reattach the pinch joint.
3. Just buy another kit. Not really a fan of this option but rather have it done properly than piecing stuff together for "good enough"
