smooth bellow
#2
Teching In
iTrader: (1)
Join Date: May 2006
Location: Cleveland, Ok
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
smooth bellow rig!
just a thought, but if you go to atwoods or most farm supply stores you can buy a straight 3in by 3in couple thats like heavy duty rubber like a 1/4 -1/2 thick for like $7 .... ive been running one on my set-up for about a year and a half now and use's less room then a smooth bellow would and has less restriction then a smooth bellow. save yourself $50 ??
#4
Teching In
iTrader: (1)
Join Date: May 2006
Location: Cleveland, Ok
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
no modifying , its actually a clean looking mod. i mean it honestly looks like just a huge *** factory rubber couple... and its straight as a arrow... no restriction and its a shorter piece compared to the SLP smooth bellow also come with the bands you will need to clamp down on throttle body and mass air meter.
putting it on is a bitch tho ... you will want to boil some water and put the couple in the hott water to loosen up the rubber to slide it over the throttle body but after the first time the piece takes shape so removal afterwards and installing is a giffy!!
way better then paying 55 or 60 or 65 dollars... just minus the slp logo!
putting it on is a bitch tho ... you will want to boil some water and put the couple in the hott water to loosen up the rubber to slide it over the throttle body but after the first time the piece takes shape so removal afterwards and installing is a giffy!!
way better then paying 55 or 60 or 65 dollars... just minus the slp logo!
#6
11 Second Club
iTrader: (15)
Join Date: Nov 2010
Location: Austin, TX
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
Yes it does... I currently have a 3'' Fenco rubber coupling from Home Depot
The crap works great! lolz
You are going to make a few cuts on the coupling to get the right angle. Once you start messing with it, you'll know where to cut. Somewhat of a diagonal cut on both ends.
And if you mess up, your only 6 bucks out of pocket. Good luck
The crap works great! lolz
You are going to make a few cuts on the coupling to get the right angle. Once you start messing with it, you'll know where to cut. Somewhat of a diagonal cut on both ends.
And if you mess up, your only 6 bucks out of pocket. Good luck