98 engine harness(auto)
repinning you can repin the six speeds wiring harness its not that hard.
Originally Posted by skinnies
Going from a manual to an auto so I'm needing an engine harness for an automatic.
you need the 4l60e connector and then you just pull the wiring that connects to the pcm look at the pinning diagram and connect wires into the pcm with pins according to what each pin does then follow the diagram for the connector and do the same..........just bypass the saftey neutral switch if you dont care about it...........takes a bit of time but its not that hard.........I have the diagrams if you would like them............no write up though.........just conect pin to pin and you will need the connectors for the wires that plug to the pin on the pcm which you can get off of any late model gm wiring harness at the junk yard...............
wiring harness uh no links actually some guy here in houston did it for me but left all the pins in the wrong place so I had to go back over his work cuz he did not return my calls. It ended up being a lot easier than I thought to pin it up........hmmmm lets see 98what I might be able to do is ask a friend to pin a 4l60e connector for you and well just send you th diagrams of what pins you need to push them into.......its not hard you would just run these wires outside of the stock pcm harness.........you pull the connector from the pcm remove the red and blue locks that hold the pins in place and push certain pins out........and replace them with the correct ones. of course and load an auto tune in the car. Ill ask him how much to assemble the wiring.......let me know if your interested........uh only thing is do you want to just bypass your saftey neutral switch ? I just took mine off....eheheheh
.... let me know if you run into any problems..............I can help ya out..........
Originally Posted by skinnies
I found a local guy to repin the harness for me. Thanks for letting me know you could do this, it's going to save me a lot of time.
