big problem after removing t56/installing T101
big problem after removing t56/installing T101 So, i pulled my T56 out, and installed a T101 nascar style gear box. now the trans wiring harness plugs are left open. it ran fine in the shop, idle, rev and all. i trailerd it to the track and ran it. the engine cut out, and felt like ignition. it did this on and off intermitantly on runs. then it died all together. now, when i can get it started (or it just cranks like its not getting spark) it runs like crap, and only stays running if i hold i about 1/2 throttle.
Any ideas? car ran great before the new tranny went in/sensors were removed...
Any ideas? car ran great before the new tranny went in/sensors were removed...
found the problem...
the ecu gorund was not bolted down. but, it was sitting next to the ground bolt and touching it when i was sitting still, then moved away under acceleration.
ill run again on thursday night and hope all goes well this time!
the ecu gorund was not bolted down. but, it was sitting next to the ground bolt and touching it when i was sitting still, then moved away under acceleration.
ill run again on thursday night and hope all goes well this time!
