narrow band
Thread Starter
Joined: Oct 2004
Posts: 1,689
Likes: 0
From: Hereford,Lubbock
narrow band I got an extra narrow band A/F gauge and wanted to install it cause i have an empty spot on my pillar pod.......Does anyone have a pinout of the PCM or know which number wire i need to tap into? I searched and read some one said it was #69 and it was purple...i looked on my pcm and my 69 didnt look purple...lol
Tapping into a signal wire like that might cause issues with the sensors feedback to the PCM. Also...be ready for a light show from the gauge any time you're not at full throttle.
ya i put mine in. its a purple wire dont remember what number it is i will look later, but i didnt cut the wire, i just shaved off some of the insulation then connected it that way.
i knew not to cut it ,cuz you might run in to issues there, like stated above.
good luck
i knew not to cut it ,cuz you might run in to issues there, like stated above.
good luck
I got an extra narrow band A/F gauge and wanted to install it cause i have an empty spot on my pillar pod.......Does anyone have a pinout of the PCM or know which number wire i need to tap into? I searched and read some one said it was #69 and it was purple...i looked on my pcm and my 69 didnt look purple...lol
