Cold Start Open-Loop
Thread Starter
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Cold Start Open-Loop Since I installed my headers and lowered my IFR to get my LTFT's negative. My cold starts sucks. I am really rich and the car will not idle till it gets into closed-loop.
What can I do to lean it out when cold and open loop?
What can I do to lean it out when cold and open loop?
You could try lowering the MVE table in the 25-50kpa MAP and 400-1200rpm range. Lower the 400rpm column by 30-40%, the 800rpm column by 20-30% and the 1200rpm column by 10-20%. Although I think this mod works better for hot starts. I recently leaned out the IFR table on my car in the MAP range of 25kpa to 45kpa and cold starts are very nice now.
Good luck.
Richard
Good luck.
Richard
