Need a raw .bin
Thread Starter
Teching In
Joined: Nov 2008
Posts: 20
Likes: 0
Need a raw .bin Tried a search and had no luck. I blanked out 4 PCMs. I got a programmer to bring them back from the dead but I don't have a .bin to load onto the chips. Can somebody help me out. I use EFI Live, so the files I have are encrypted. I need a raw bin.
Also If anyone knows were/how I need to put the ID in there so that I can use the licenses that I burnt on these that would be great.
Also If anyone knows were/how I need to put the ID in there so that I can use the licenses that I burnt on these that would be great.
Thread Starter
Teching In
Joined: Nov 2008
Posts: 20
Likes: 0
just about any osid should work but no etc. Reason I need it is mainly for the boot portion of the chip, the calibrations don't matter because once I get the pcm booting up again, I'll recalibrate it with EFI LIVE. Maybe throw a couple my way so I can fumble through.
pcm is 12200411
Thanks
pcm is 12200411
Thanks
Thread Starter
Teching In
Joined: Nov 2008
Posts: 20
Likes: 0
any advise on the reprogramming? I'm using a willem and so far no luck. Chip is programmed fine and verifies ok but the pcm still is dead.
For example, do I need to set an offset or invert the data?
For example, do I need to set an offset or invert the data?
Last edited by turbogtu; Oct 7, 2009 at 05:55 PM.
