LC1 & Digital Gauge
07-08-2010, 08:53 AM
#1
TECH Addict
Thread Starter
iTrader: (5)
Join Date: Mar 2002
Location: VA
Posts: 2,320
Likes: 0
Received 0 Likes
on
0 Posts
LC1 & Digital Gauge I had an old Digital gauge laying around so i installed on the LC1 analog output. I tired the Brown and the readings were showing 1-5 A/F and it is all over the place.
I then tried the 0-5v output which is the Yellow wire and it showed a more consistent 24 AF at idle & 18 at WOT. Now both gauge readings are not right since i have a digital signal going to my V2 Flashscan and it is reading properly (mids 12's AF).
What i need is how can i make this gauge read properly? Can i tune the LC1 to provide a better suited signal to the digital gauge i have?
I then tried the 0-5v output which is the Yellow wire and it showed a more consistent 24 AF at idle & 18 at WOT. Now both gauge readings are not right since i have a digital signal going to my V2 Flashscan and it is reading properly (mids 12's AF).
What i need is how can i make this gauge read properly? Can i tune the LC1 to provide a better suited signal to the digital gauge i have?
